The Official
Website of the
International
Sailing Federation

www.sailing.org
15 December 2003, 10:15 am
World's Tallest Mast Produced
No ALT tag specified

Mirabella V
Gosport, Hampshire

VT Halmatic has completed production of the world's tallest yacht mast, which will be fitted on the Mirabella V under construction by parent company VT Shipbuilding.
The 90m. hollow carbon epoxy mast, which has a maximum cross section of 1.6 metres and structural thickness of up to 40mm, will support some 3400 square metres of sail.

Having been loaded onto a barge at VT Halmatic's Portchester shipyard, the mast was transported to Southampton Docks where the rigging will be dressed and the mast will be stepped before fitting out is completed.

The mast has been manufactured in halves, with the back half comprising two sections and the front half divided into three sections.

The manufacturing process, a similar method to that used in the production of Grand Prix racing cars and the aerospace industry, consists of layers of carbon reinforcement pre impregnated with epoxy resin. A vacuum bag is used to consolidate the carbon every few layers.

The mast sections were cured using a heat process with temperatures up to 70 degrees centigrade.

Carbon compression tubes were pre-fitted to coincide with the position of each spreader. Some five tonnes of cabling have been fitted within the hollow centre of the mast, including a mass of sensors to monitor the sail performance.

Structural expertise was provided by Hamble-based High Modulus, who are involved in composite engineering aspects for the total Mirabella project. Finally, the sections of the mast were glued together using an epoxy adhesive.

VT Press Room (As Amended By ISAF News Editor)
Share this page
Isaf TV
Latest News
News Archive
© 2014 Copyright ISAF/ISAF UK Ltd. All Rights Reserved Privacy & Cookies delivered by Sotic powered by OpenText WSM